![]() I started with Auto-Stop value of 1.0 (will correct that to 0.5)Ĭontrol-type: actually tried with pelco-d_ffmpeg, onvif aso (thanks for the update, that onvif is not realy implemented). (please ignore the this a result of a hexToAnsii conversion of delimiters) Fire up wireshark, watch the onvif soap messages go to the camera and see what the soap response is. If that still does not work, then you have to do this the hard way. I leave that portion up to someone else with the time and a camera that supports it. ![]() My netcat camera accepted all onvif commands regardless of the authentication I used (scary) thus preventing me from adding authentication to the script. 0.50ĭon't add user credentials because they aren't supported. It is probably in the url you used to get the stream.Īlso, put a value in to Auto Stop Timeout e.g. You have to figure out the onvif port for your camera. In your Control Address field, put your ip address and the onvif port the camera responds to e.g. The control script called "onvif" actually is not onvif at all and should either be deleted or replaced. every other tool works and i bet there is some mistake i made.Īt the moment, the Netcat control script I wrote is the only script in the zoneminder project which sends actual Onvif SOAP messages. my best result was 'connection reseted by peer'. (I also tested the combination of usr/user & pwd - according to some foscam settings)īut i have no success. ![]() With empty 'control device' or set to the path /onvif/device_service (according to the identifaction given by 'onvif dvc mgr'). In the monitors-settings the controllable-flag is enabled. In zoneminder the zm_opt_controls flag is enabled the version is 1.30.0 (onvif-probe enabled). The cams rtsp-channel works fine it's port is 554 and its also attached to the uri. ![]() the probe finds every device and lists some soap-structures.įfmpeg - modect - rtsp/unicast (i'll provide the login with the uri in 'source' The system (T38G006-ONVIF-P2P) is actually equipped with a zoom-motor and now I want to run it with zoneminder.Īccording to the docs I am using over a ubuntu 16.04 console. I ended up with iSpy, which is able to probe my onvif devices and correctly passes the commands to the underlying pelco-d system (onvif device mgr works too). to make sure everything works over onvif I used several tools. my main intend is to use onvif for controlling motors. Actually I am testing several optronical devices.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |